Lights/Screws/Fuse
The two lights for this project are 12v Pre-Wired Warm LED Diodes. They have an in-line resistor on the negative wire and are great for any DIY projects.
There are 3 different types of screws in this kit not including the screws that come with the servos.
- 2x6 Panhead Screws-Used for locking down the servo horns
- 2.6x6 Truss Head Screws
- 2.6x8 Truss Head Screws
The fuse for this project is a 5x20 mm 5 A 125 V fuse(Not shown above but is included in the kit). If you're using the Fenix batteries such as the ones I highly recommend chances are you will never have to replace this as the overcurrent/short-circuit function on the Fenix batteries will kick in before the fuse blows. If you're using other 16340 batteries that don't have that built in protection, the fuse is there to still protect the circuit board and batteries but there's good chance you might let the magic smoke out of a few components. The beauty of this is that replacement parts can be sourced for cheap and swapped without any headache.