Placing PCB Components

Parts Required

1. 1x ESP32 Development Board
2. 1x 5v Buck Converter
3. 2x DRV8833 H-Bridge's
4. 1x 5a Fuse

STEPS

1. Press the ESP32 Development Board into place, align the USB port with the white square on the ProfessorBoots PCB.
2. Press the 2 H-Bridges into place, line up the EEP pins on the H-Bridges with the corresponding EEP labeled receiver pins.
3. Press the 5v Buck Converter into place with the majority of the board hanging down.
4. Open the fuse holder and insert a 5a fuse, close the holder.