Mounting Servo's

Parts Required - Vary Based on Configuration

1. 2 MG90S Assemblies
2. 1x 3D Printed Quick Swap attachment plate
3. 1x 3D Printed Attachment of choice "I'll be using the standard bucket"
4. 1x 3D Printed Claw "This isn't necessary and if you don't want it simply skip the steps regarding it"
5. Claw requires two 2 2x8mm Truss Screws

STEPS

1. Take 1 MG90S servo and mount it to the quick swap attachment plate with the gear protrusion on the bottom. Using the 2 longer silver screws that come in the servo bag assembly lock the two tabs on the outside of the servo in place.

1. Slide the bucket top down onto the quick attach piece until the clips lock onto the top of the bucket. The first couple times this happens there will be a fair amount of friction though if you cant get the bucket on at all or the bucket is really loose consider checking out the folder "Alternate Sizes" and download/print the appropriate piece for your situation.

1. If installing the claw take 1 MG90S servo and mount it to the claw cutout with the gear protrusion on the inward side of the model. Same as before use the 2 longer silver screws to lock it in place.

1. If installing the claw secure the claw to the bucket using 2 2x8mm Truss Screws.